Difference between revisions of "Special Application of Analog Gateway – Remote Station"
(Created page with "Remote Station <br /> The following operation is supported:<br /> 2001~2009 can achieve all functions of the extension;<br /> Follow the steps below to c...") |
(No difference)
|
Revision as of 17:46, 2 June 2015
The following operation is supported:
2001~2009 can achieve all functions of the extension;
Follow the steps below to configure Analog Gateway 1.
1)Do SIP settings.
Set the LAN for SIP call processing.
2)Do FXO settings.
Set the SIP account for each FXO port and the number requiring Static Binding. Here both the SIP account and the bound number are the number of an extension connected with the FXO port. To make them the same can help achieve the two-way binding feature without adding TELIP rules.
3)Set TEL IP routing.
Set to switch all calls coming into the FXO port to Analog Gateway 2 (IP address: 201.123.114.192)
4)Do FXO parameter settings.
Note that by default the feature ‘Two Stages Dialing Mode’ set under Outgoing PSTN Call is not enabled.
Follow the steps below to configure Analog Gateway 2.
1)Do SIP settings.
Set the LAN for SIP call processing.
2)Do FXS settings.
Set the SIP account for each FXO port. Here the use of numbers of the extensions connected with PBX makes the call logic more clear.
3)Set TEL IP routing.
In case the FXS port makes a call out, only the call with the start extension number of Gateway 2 will be switched to Gateway 2 while any other calls will be switched to Gateway 1(IP address: 201.123.114.252).
