Special Application of Analog Gateway – Remote Station

From synwaywiki
Revision as of 17:46, 2 June 2015 by Admin (Talk | contribs) (Created page with "Remote Station <br /> The following operation is supported:<br /> 2001~2009 can achieve all functions of the extension;<br /> Follow the steps below to c...")

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Remote Station
The following operation is supported:
2001~2009 can achieve all functions of the extension;
Follow the steps below to configure Analog Gateway 1.
1)Do SIP settings.
Remote Station
Set the LAN for SIP call processing.
2)Do FXO settings.
Remote Station
Set the SIP account for each FXO port and the number requiring Static Binding. Here both the SIP account and the bound number are the number of an extension connected with the FXO port. To make them the same can help achieve the two-way binding feature without adding TELIP rules.
3)Set TEL IP routing.
Remote Station
Set to switch all calls coming into the FXO port to Analog Gateway 2 (IP address: 201.123.114.192)
4)Do FXO parameter settings.
Remote Station
Note that by default the feature ‘Two Stages Dialing Mode’ set under Outgoing PSTN Call is not enabled.
Follow the steps below to configure Analog Gateway 2.
1)Do SIP settings.
Remote Station
Set the LAN for SIP call processing.
2)Do FXS settings.
Remote Station
Set the SIP account for each FXO port. Here the use of numbers of the extensions connected with PBX makes the call logic more clear.
3)Set TEL IP routing.
Remote Station
In case the FXS port makes a call out, only the call with the start extension number of Gateway 2 will be switched to Gateway 2 while any other calls will be switched to Gateway 1(IP address: 201.123.114.252).

Retrieved from "https://wiki.synway.net/index.php?title=Special_Application_of_Analog_Gateway_–_Remote_Station&oldid=276"